7
DynaQuip Controls • 10 Harris Industrial Park • St. Clair, MO 63077
Tel. 800-545-3636 • Fax. 636-629-5528 • www.watercop.com
Additional Components Available for Your WaterCop
®
CLASSIC System
Installation Guide
IMPORTANT!
Adherence to all local and municipal building, plumbing and electrical codes as they pertain to the installation of the
WaterCop
®
CLASSIC System is of utmost importance . Codes in some areas may require that a licensed plumber be
employed to do the installation, or that the proper permits be obtained prior to any installation . Even if local codes do not
require a licensed plumber to do the installation, it is necessary that the installer has a professional level of competence
in both plumbing and electrical skills to perform the installation . These instructions assume this level of knowledge and
skill . If in doubt, use a licensed professional .
Pre-Installation Testing of WaterCop
®
Although each unit is pre-tested at the factory, it is highly recommended that the unit be tested prior to installation to
ensure proper operation in your home . Operating the valve before connecting to the water line will not damage it .
Use caution!
CAUTION!
•
The valve closes with great force. It could cut off a finger.
•
Keep fingers and other items out of the valve when testing.
WARNING!
The WaterCop
®
case is NOT EXPLOSION PROOF. The shut-off valve must NOT be
installed where it could ignite flammable vapors or explosive mixtures.
WARNING!
To reduce risk of electrical shock, fire, or damage to property or WaterCop
®
:
Do not use extension cords. Use of extension cords can cause fires or electric shock. Install
WaterCop
®
within 20 feet of an outlet or, install an outlet near the WaterCop
®
. Comply with
all local codes.
STOP
STOP
Single and Dual Probe WaterCop
®
Flood Sensors
WCDFS1
(single probe) and
WCDFS2
(dual probe)
•
Battery or AC (optional) powered
•
Transmits wireless signal to valve when moisture
is detected
•
Unlimited number can be used, placed anywhere
•
10’ sensor cord, white
Low Temperature Sensor
WCDFST
•
Monitors temperature of pipes prone to freezing
•
Sends wireless signal to turn off water if low
temperature detected
•
10’ cord with clip to attach to pipe
•
Flood sensor with probe
Water Control Wall Switch
RS100
•
Proactively turn water on or off from convenient location
•
Lighted display to valve position (on or off)
•
Requires category 5E cabling connection to valve
(see Wall Switch Interconnect Cable below)
AC Power Adaptor
•
For WCDFS1, WCDFS2, and WCDFST sensors
•
Eliminates the need for AA batteries
WaterCop
®
/ Wall Switch Interconnect Cable
CBL50
(50 feet) and
CBL100
(100 feet)
•
Required to connect WaterCop
®
valve with Water
Control Wall Switch
•
RJ45 molded connections for easy installation and
durability
