Dynapos DCI020-M, Техническое руководство

Страница: 2 / 21

1. Main parts and function introduction
1.1 hopper
:
Using as bracket for bills loading, bills run
smooth when the gap of hopper and feeding
roller is proper. The machine operates while
the feeding sensor incept anything.
1. 2 magnetic board
Structure of bill counter’s sensor passing,
The main magnetic head is used to detect whether the detected bill has magnetism printing ink or if
the bill’ safety line has magnetic element(this function only suits for models with UV/MG),
therefore, the non-magnetic note doesn’t work with MG-detect machine. There is an proper gap
between the rotated roller on the magnetic board and impeller
，
which pulls
note out from hopper when machine operates ,so that note finish its passing
work.
1. 3 UV assembly
Using the law of refection, ultraviolet radiation
from two UV bulbs goes through the note to silicon cell, the model can
check out the UV element notes after the cell got the signal and systems
analysis(this function only suits models with UV/MG)
1.4 counting sensor
This counting sensor installed two IR receiver,
emit the IR signal by two IR launch from magnetic board, then
according to the changing of voltage in the period of notes passing, the
machine can count note accurately.
1.5 main motor
Hopper
Counting sensor
Main motor
Magnetic board
Counting sensor