Dynapac LH800, Руководство по эксплуатации и техническому обслуживанию

Страница: 7 / 30

7 ILH800EN2
SAFETY WHEN DRIVING
Slopes
Max 19°
or 35%
Tipping angle on side slopes
When driving near an edge, at least two thirds of the
plate must be on firm solid ground.
If the machine tips over, switch off the en-
gine before attempting to lift the machine.
Make sure that the work site is safe. Wet and loose
earth reduces manoeuvrability especially on sloping
ground. Always observe particular caution on sloping
and uneven terrain.
Where possible, avoid all driving across a
slope. Instead, drive up and down on sloping
ground.
Never work on slopes that are greater than the capabil-
ity of the machine. Maximum slope of the machine in
operation is 19° (depending on condition of the ground).
The tilting angle is measured on a hard, level surface
with the machine stationary. Vibration switched OFF
and all tanks full. Remember that loose ground, vibra-
tion switched ON, and driving speed can all cause the
machine to topple even on a smaller slope than speci-
fied here.
Never leave the machine unattended with the
engine running.
Driving near an edge
Machine location when operating
on edges
Max 19°
or 35%
Tipping angle on slopes
L000333A
L000334A
L000335A
At least
2/3
WARNING
WARNING
WARNING