Dynapac Hatz F80W, Руководство по ремонту

Страница: 146 / 246

142 F80W
D
MIN
MA
X
1
2
3
4
D
D451198
451120
STOP
12V
0V 14V
D452023
11
12
STOP
12V
0V 14V
24
D452024
13 Screed gas heating
13�7�3 Gas flame adjustment
Open the access to the burners.
Insert the key into the ignition box (11) in the position “0” and
switch over to the position “I”.
Set the key between position “I” and “II” and the engine glowing
indicator lamp (24) will light up.
Do not perform engine glowing for more than 15 s.
Use the alarm horn (12) to signal that the engine is starting.
Turn the key to position “II” to start the engine.
Secure the screed against free fall.
Set the maximum paving width on both sides of the machine.
Turn the key in the ignition box (11) from position “II” to position
“I”. The engine switches off.
Turn the key in the ignition box (11) from position “I” to position
“0” and disconnect the battery disconnecter.
Have the correct position of the gas flame adjusted.
Have the flame position adjustment performed by an author-
ised service plant or qualified personnel according to the pro-
cedure given below.
Adjust the distance (D) between the gas burner (3) and the
spark plug (4).
Adjust the distance (D) by loosening the gas burner set screw (1)
on the burner holder (2).
The distance (D) can only be adjusted within the MIN and MAX
marks. The values of MIN and MAX are marked on the burner
holder (2) by marks.
After adjusting the burner (3), tighten the burner set screw (1)
on the burner holder (2).
Test the ignition of the burners. In case of incorrect adjustment,
repeat the gas flame adjustment procedure.
Perform gas flame adjustment when the machine is
parked on a flat and solid surface with the engine and
battery disconnecter off�
Have the gas flame adjustment performed by an author-
ised service plant or qualified personnel according to the
given procedure�
There is a risk of burns� Use protective equipment�
There is a risk of explosion�
Do not smoke during machine operation� There is a risk
of explosion or fire� Liquid gas can easily ignite�
The machine must be equipped with a fire extinguisher�
Have the fire extinguisher ready on the driver's stand at
a place intended for this purpose�