Dynapac F1800C, Руководство по эксплуатации и техническому обслуживанию

Страница: 201 / 348

D 40.18 9
Now try to start the other vehicle:
- Turn ignition key (3) to position 1 and wait for the preheat check (8) (
o
) to go off.
A
The vehicle cannot be started if the indicator lamps are on:
- "Start inhibit" (4) - Emergency stop button (5) pressed
- "Error message" (6) - drive lever (1) swivelled out
- "Engine error with stop" (7) - engine error with start inhibit.
- Press the starting button (9) to start the engine.
Do not let the starter run permanently for more than 20 seconds, then allow
for a break of one minute!
A
If the engine does not start and the Error message (5) indicator lamp flashes,
then the electronic engine control system has activated the start inhibit.
To deactivate the start inhibit, turn the system off with the ignition key (3)
for approx. 30 s.
- If the engine still has not started after two attempts, ascertain the cause!
- If the engine starts up: disconnect the starting aid cable again in reverse order.