Dynapac CC 222, Руководство по обслуживанию

Страница: 19 / 33

17 CC 222/222C - CC 232/232C - CC 322 M222EN5
EVERY 50 HOURS OF OPERATION (Weekly)
See the Operation manual for how to oper-
ate the edge cutter.
Grease the four points indicated in the figure.
Additional lubrication should also be with grease, see
Lubricant specifications.
Grease all bearing points with five strokes of a hand-
operated grease gun.
Edge cutter (Optional) -
Lubrication
Fig. 24 Four lubrication points
1
4
2
3
Never use an open flame when checking
the electrolyte level. Explosive gas is gen-
erated when the alternator is charging.
Open the left door of the engine compartment.
Turn both quick-screws in the plate over the battery 1/4
turn counter-clockwise and fold out the plate.
Wear safety goggles. The battery contains
acid. Rinse with water if electrolyte comes
into contact with the body.
Take off the cell caps and make sure that electrolyte is
about 10 mm (0.4 in) above the plates. Check the level
of all cells. Top off with distilled water to the right level if
the level is low. The engine should be run for a while
before topping off with distilled water if the ambient
temperature is below freezing. Otherwise, the electro-
lyte might freeze.
Make sure that ventilation holes in the cell cover are
not clogged. Then put the cover back on.
The cable shoes should be clean and well tightened.
Clean corroded cable shoes and grease them with
acid-free Vaseline.
When disconnecting the battery, always
disconnect the negative cable first. When
connecting the battery, always connect the
positive cable first.
Discard used batteries properly. Batteries
contain lead, which is detrimental to the envi-
ronment.
Before doing any electric welding on the
machine, disconnect the battery ground
cable and then all electrical connections to
the alternator.
Fig. 26 Electrolyte level in battery
1. Cell cap
2. Electrolyte level
3. Plate
Battery - Checking
the electrolyte level
2
1
Battery cell
3
Fig. 25 Battery space
1. Battery
2. Cell cap
3. Cable shoes
1
2
3
10 mm
(0.4 in)
CAUTION
WARNING
WARNING
WARNING
WARNING