Dynapac CA282D, Инструкция по эксплуатации

Страница: 94 / 119

Maintenance - 50h
ICA282-1EN3.pdf 2012-06-18
Tires - Air pressure - Wheel nuts - Tightening
Fig. Wheels
1. Air valve
2. Wheel nut
1
2
Check the tire pressures using a pressure gauge.
If the tires are filled with fluid, the air valve (1) must be
in the "12 o'clock" position during pumping.
Recommended pressure: See Technical
Specifications.
Check the tire pressure.
When changing the tires it is important that both
of them have the same rolling radius. This is
necessary to ensure proper functioning of the
anti-slip in the rear axle. When changing the tires it is important that both
of them have the same rolling radius. This is
necessary to ensure proper functioning of the
anti-slip in the rear axle.
Check the tightening torque of the wheel nuts (2) at
630 Nm (465 lbf.ft).
Check both wheels and all nuts. (This only applies to a
new machine or newly fitted wheels).
Check the safety manual that accompanies the
roller before filling the tires with air. Check the safety manual that accompanies the
roller before filling the tires with air.
Automatic Climate Control (Optional) -
Inspection
Fig. Drying filter
1. Sight glass
1
The system described in this manual is type ACC
(Automatic Climate Control).
Never work under the roller when the engine is
running. Park the roller on a level surface, chock
the wheels and depress the parking brake control. Never work under the roller when the engine is
running. Park the roller on a level surface, chock
the wheels and depress the parking brake control.
With the unit in operation, open the engine hood and
check using the sight glass (1) that bubbles are not
visible on the drying filter.
The filter is located on the left side of the engine
compartment's front edge. If bubbles are visible
through the sight glass, it is a sign that the refrigerant
level is too low. If so, stop the unit. The unit may be
damaged if it is run with insufficient refrigerant.
84