Dynapac CA152A, Руководство по обслуживанию

Страница: 27 / 37

25 CA152A M152AEN2
1
2
2
1
1
Rear axle planetary gears
– Oil change
EVERY 1000 OPERATING HOURS (EVERY SIX MONTHS)
Fig. 46 Planetary gear/filling position
1. Plug
Fig. 45 Planetary gear/drainage position
1. Plug
Fig. 47 Cab
1. Fresh air filter
2. Screw (x2)
Loosen the two screws (2) at the right-hand side of the
cab. Lift down the whole holder and remove the filter
insert.
Replace with a new filter.
It may be necessary to replace the filter more often if
the machine is used in a dusty environment.
Fresh air filter – Replacement
Position the roller with the plug (1) at its lowest position.
Wipe clean, unscrew the plug (1) and drain the oil into a
suitable receptacle. The volume is about 2 litres (2.1 qts).
Save the oil and deposit it in an approved
manner.
Position the roller with the plug at 9 o’clock.
Fill with oil to lower edge of level hole. Use transmis-
sion oil. See lubricant specification.
Clean the plug and screw back in.
Change the oil in the same way as the other planetary
gears of the rear axle.