Dynamic DX Power Module PMB, Руководство по установке, Страница: 40 / 85

3URJUDPPLQJ
35
If more than one type of wheelchair is to be used by the customer, each wheelchair
type may have its own set of optimum settings. In this case, it is generally best for
Dynamic to supply DX Modules with a standard set up, and for the wheelchair
manufacturer to change the programming, using the Wizard, as required by their
production.
Warning :
If a wheelchair is programmed with settings other than default, under
some very rare fault conditions default settings could be automatically restored,
thereby changing driving characteristics. This in turn could lead to a chair moving
in a direction or speed that is not intended. Programmers should consider this risk
when programming settings other than default.
$XWR'RZQORDG
The DX System has a feature called Auto Download. It is designed to minimise the
programming requirements associated with Module servicing by down loading the
correct programming to a replacement DX Module.
When a DX Module is replaced, it is likely that the replacement module is
programmed differently from the one that it replaces. This could leave the
wheelchair in a dangerous condition. The DX System automatically detects that a
DX Module swap has occurred, and the programmed data from the old module is
transferred to the replacement module.
Auto Download is achieved by the DX Remote containing both its own
programming and also a backup copy of the programmed data for all other DX
Modules. When a module swap is detected, or a checksum error found in a module,
the DX Remote automatically downloads its backup copy to the module.
Note : The Auto Download occurs immediately on power up after the Module
has been replaced. This applies to all intelligent DX Modules except a DX
Remote.
A DX Remote replacement will normally have the desired programming for the
wheelchair. The fine tuning of the Drive Programs to suit the individual wheelchair
user will however be necessary.