Dynamic DS120, Руководство по установке, Страница: 59 / 128

Chapter 4: Programming the Rhino2
59
4.3 Parameter List
Key:

Editable at this level (

* = HHP Technician Mode)

Viewable at this level
Note:
Some of the parameters in this list have a limited settable resolution; if a
parameter value is set by an amount that is smaller than the parameter’s step-
size, the parameter’s value will be rounded to a value as close as possible to the
set value.
Parameter Possible Values Default HHP Lite Std Adv
User Personalisation (4.4.1)
Sleep Timer 0 - 30min 30min
 
Wakeup Style
Key + Throttle
Key Only
Key Only

Swap Throttle Direction No / Yes No
   
Enable Beeper No / Yes Yes
   
Flash Code Beeper No / Yes No    
Sleep Beeper No / Yes Yes
   
Motion Beeper
None
Reverse
Forward/Reverse
Reverse
   
Beeper On Time 100 – 1500ms 300ms   
Beeper Off Time 0 – 1500ms 700ms
  
Deep Discharge Beeper No / Yes Yes
  
Sleep on Fault or Inhibit No / Yes Yes   
Power Off after Sleep No / Yes Yes
  
Throttle Configuration (4.4.2)
Throttle Type
Wig-wag
Single-ended
Uni-polar
Wig-wag




Throttle Input
Single
Dual
Single    
Throttle Neutral Offset -0.63 - +0.62 V 0 V   
Throttle Full Scale Deflection 20 - 100 % 75 %
  
Throttle Response 0 - 100 % 80 %
   
Throttle Dead-band 0 - 100 % 25 %    
Throttle Testing No / Yes Yes
 
Maximum Throttle Voltage 0 - 5V 4.90V
 
Minimum Throttle Voltage 0 - 5V 0.10V  
Throttle OONAPU Testing
None
Non-Latching
Latching
Latching
 
Throttle Fault Non Latching No / Yes No
 
Speed Limit Pot No / Yes No  
Slam Brake Enable No / Yes No

Slam Brake Threshold 0 - 100 % 40 %


Enable SRW Open Circuit Testing No / Yes No    