Chapter 3: Installation and Testing
40
Slow
Slows the scooter to a set speed limit (a percentage of the
maximum speed). Has no effect on scooter acceleration or
deceleration.
Available on Tiller Connector Pins 4, 6, 12, and 14 and
Charger/Programmer Connector Pin 4.
Slow/Stop
This function has three states: Inactive, Slow and Stop.
When Slow is active, the scooter will
slow to a programmed speed limit (a
percentage of the maximum speed).
Has no effect on scooter acceleration
or deceleration.
When Stop is active, the scooter will
stop at the programmed Emergency
Deceleration rate.
Available on Tiller Connector Pins 4, 6,
12, and 14 and Charger/Programmer
Connector Pin 4.
3.10.8
Tiller Battery Supply
Pin 7 provides the Battery Positive (B+) supply to the tiller, while Pin 13 provides the Battery
Negative (B-) return. These pins have current ratings of 9A and can be used for wiring an XLR
socket for an off-board battery charger. An external fuse (maximum rating of 8A) should be
installed into the Battery Positive circuit. Refer to Section 3.7 for further details about battery
charging.
The B+ and B- supplies must not be connected either directly or through switches to the same
input connector.
Warnings:
A suitable fuse (maximum rating of 8A) must be installed in the Battery Positive wire
to protect the scooter wiring. Fuse to be connected as close as practical to the
controller connector, to minimise the length of unprotected wiring.
In connecting switches between an input pin and either Battery Positive or Battery
Negative, the installer must ensure that there is no possibility of the switch(es)
connecting Battery Positive to Battery Negative.
B+ (if Active High)
B- (if Active
Low)