22
Copyright © 2014 - 2020 Dynamic Projection Institute GmbH. All rights reserved. http://www.dynamicprojection.com
Weights and dimensions shown are approximate. Specifications and appearance are subject to change without notice.
The motors make a bird singing like noise
when moving.
Broken motor driver cable or connection socket problem.
Please contact our support.
The LCD does not show anything when
the power-cord is connected.
Check if you have power on the power-cord. If there is power and
the unit does not show any response please disconnect the unit and
contact our support. Do not use the unit anymore. Do not open the
unit - danger of electric shock!
The motors make a high pitched constant
noise when standing still.
This is due to the magnetic field inside of the motors. The Mirror Head
is designed to avoid this as best as possible. You can try to move the
position of the mirror by a few steps over DMX to go into a position
where you do not hear it anymore. NOTE: Please keep in mind that
during normal operation the Mirror Head is mounted far away from the
observer of the projection and the ventilation of the projector and/or
the environment is much louder than the sound of the motor.
How much does the Mirror Head influence
the throw-ratio?
The Mirror Head does not change the throw ratio at all. For throw-ratio
calculations use the distance from the mirror to the wall and then add
0.08m (distance mirror center to lens).
The image turns when the mirror moves
from left to right.
This is due to the physics of reflection.
How fast does the mirror move?
The terminal velocity is about 60°/sec.
The projector does not respond when sending
lamp on/off or any other command.
Check if you set the correct projector in the control unit. Make sure
the Baud-rate settings on the projector are correct and that the serial
communication is enabled.
Version 2.4
