Install Video at
www.DynamicMounting.com/Install
7
7
Conditions for Mounting the Frame to the Wall
1.
The TV must be centered on the mount to avoid leaning.
2.
The mount is designed to attach to standard 2 x 4 or larger wall studs. If the wall isn’t sturdy enough then more support will need
to be added, consult an expert.
3.
The mount must be securely fastened to a structure that can support 4 times the total weight of the television and mount.
Dynamic Mounting assumes no responsibility for damage from an improperly installed mount.
4.
The mounting holes need to be in the center of the studs, use a stud finder as needed.
5.
2 lag screws are needed in the top slots of the mount and 2 in the bottom slots.
6.
2 lag screws need to be on each side of the center of the mount and the center of gravity of the television.
Important: The TV needs to be centered on the mount to avoid leaning
Mounting Frame to Wall
1.
The television should be centered on the mount, if not the
television will sag to one side. The heavier the TV and the
more off center, the more unlevel the TV will be through its
range of motion.
2.
Mark the locations of the mounting holes by Using the
Frame as a template
3.
Once you know your location, pre-drill 1 of the top row of
mounting holes 2.5in deep using the 1/4in drill bit.
4.
Figure 10 shows the correct order to put on the lag screw.
5.
Use a 9/16in wrench to install the lag screw; do not tighten
all of the way down yet.
6.
Level the mount as shown in Figure 8.
7.
Mark and drill the other 3 holes 2.5in deep.
8.
Install the lag screws and tighten until the mount is firmly
pressed against the wall. Do NOT over tighten.
9.
In some situations the mount will interfere with a lag screw,
Remove the lag screw.
Follow the directions in the Attaching Mount to Frame
Section Below.
Put the Lag Screw through the Mount and Frame.
Attaching Mount to Frame
1.
Figure 10 shows how to attach the Mount to the Frame.
2.
Hook Mount over the top of the Frame.
3.
Swing Bottom in.
4.
Ensure Mount is on the Centerline of the TV.
5.
Use the 5/16” Carriage Bolts and Locknuts to lock in the
bottoms of the frame and mount together.
Figure 10, Frame Attach
