DynaGen OPT2600-2-120/240V, Инструкция по установке и эксплуатации

Страница: 7 / 22

7
1:2:2 System Operation:
WARNING: THE RELAY BOARD IS FACTORY SET FOR 12VDC
APPLICATIONS. IF INSTALLING IN A 24VDC
SYSTEM, TWO JUMPERS NEED TO BE CUT.
The relay board module has provisions for 12 and 24 VDC operation. The relay board
comes factory set for 12 VDC applications. Changing from 12 to 24 VDC will require
cutting the 2 jumper wires located next to the 5-position header
2: INSTALLATION INFORMATION
2:1 General
The basic OPT2600 transfer switch includes all control wiring connections. The electrical
switchgear should be installed by a certified electrician, and all wiring to/from the unit
should agree with all applicable electrical codes, standards, and practices.
2:2 Recommended Upstream Protection
When protected by a circuit breaker rated 600A maximum. This switch is suitable for use
on a circuit capable of delivering not more than:
65,000A RMS SYMMETRICAL AT 240V
35,000A RMS SYMMETRICAL AT 480V
25,000A RMS SYMMETRICAL AT 600V
When protected by a class J, T or R fuse rated 600A maximum. This switch is suitable
for use on a circuit capable of delivering not more than:
100,000A RMS SYMMETRICAL AT 240V
100,000A RMS SYMMETRICAL AT 480V
May open circuit above 4,000A
Use copper or aluminum wiring at a minimum 75C rating for power terminals.
User Manual for the OPT2600 Series
Automatic
Transfer Switch