DynaGen OPT2600-2-120/240V, Инструкция по установке и эксплуатации

Страница: 22 / 22

22
12.
Press the PROGRAM button once more to set the day and time for ending the
exercise. A default time AM 12:00 appears in the display. A small 2 appears to
the right of the time. The lamp symbol is absent. The 2 (or even number)
indicates the end of an exercise or open contacts. The absence of the lamp symbol
indicates when the exerciser contacts will open.
13.
Press the DAY button repeatedly until an arrow appears under the desired day for
terminating the exercise (Monday = 1) as in step 9.
14.
Press the MINUTE button repeatedly until the desired minute of the exercise
termination hour is displayed, such as AM 5:40 or PM 5:40.
15.
Move the slider on the SET switch to the "run" position. The exerciser time clock
is now programmed to start the emergency generator at the desired day, time and
for the desired duration.
NOTE: It is possible to program one to eight "on - off" cycles or transitions for the
following day combinations: One to eight "on-off" cycles any day of the week; One to
eight "on-off" cycles Monday to Friday inclusive; One to eight "on-off" cycles both
Friday and Saturday only; One to eight "on-off" cycles Monday to Saturday inclusive;
One to eight "on-off" cycles Monday to Sunday inclusive; All day combinations can have
any combination of "on -off " cycles
. Normally the exerciser time clock will only
require one "on-off" cycle once per week. The programming steps given above describe
how to exercise the generator once a week.
EXAMPLE
: Suppose that the desirable day
and time for exercising the generator is Saturday at 5:00 AM. Move the slider of the
SET
SWITCH
to the right (P in circle) position. Press the
DAY BUTTON
(1..7) repeatedly until
the arrow appears under day 6. Press the
HOUR BUTTON
(h) followed by the
MINUTE
BUTTON
repeatedly until the desired time
AM
5: 30 are displayed. The generator is to be
shut down after exercising for 10 minutes. With the slider of the
SET SWITCH
still in the
right (P in circle) position press the PROGRAM BUTTON once . The display will show
a continuous default time of
AM
12:00. The day arrow(s) disappears. The small 1 will
change to a 2 and the lamp symbol disappears. Press the DAY BUTTON (1..7) again
repeatedly until the day arrow appears under day 6. Press the
HOUR BUTTON
(h) followed
by the
MINUTE BUTTON
again repeatedly until the desired time
AM
5: 40 are displayed.
Return the
SET SWITCH
slider to the "run" position. The exerciser time clock is
programmed to start the generator at 5:30 AM on Saturday morning and run for 10
minutes then shut down at 5:40 AM of the same day Saturday. Following this procedure,
the generator can be exercised as frequently as desired.
User Manual for the OPT2600 Series
Automatic
Transfer Switch