DynaGen GSC300, Руководство пользователя

Страница: 17 / 21

Operating & Installation Manual for the GSC300 Engine Controller
17
Programming The GSC300 Settings
Using the Front Panel Interface:
The following table shows the LED’s that correspond to the various settings of the various parameters. To
enter the controller into Program Mode, you need to turn the small switch at the bottom edge of the controller to
the program position. This Mode Switch can be set using a ballpoint pen or such to allow the controller to be
put into Program Mode. The first three LED’s (3, 2 & 1) correspond to which parameter is being adjusted, and
the next three (6, 5 & 4) LED’s show the setting for that particular parameter. The picture on the next page
shows the LED numbering and the location of the Mode Switch.
▼ LED's 6, 5 & 4 ▼
Parameter
LED's 3, 2 & 1
▼ ○○○ ○○● ○●○ ○●● ●○○ ●○● ●●○ ●●●
Crank Tries
○○○ 1 2 3 4 5 6 7 8
Crank Time
○○● 5 10 15 20 25 30 35 40
Rest Time
○●○ 0 5 10 15 20 25 30 35
Preheat Time
○●● 0 5 10 15 20 25 30 35
Cool-Down
●○○ 0 32 64 96 128 160 192 224
Preheat/ETS/
Warm-Up
●○●
Preheat ETS Warm-Up
N/A N/A N/A N/A N/A
Warm-Up
●●○ 0 28 56 84 112 140 168 196
To scroll through the parameters simply press the Auto button on the front panel of the GSC300. To scroll
through the range of values for that parameter simply press the Manual Start button. To set the value into the
controller’s memory, press the OFF button. In this manner the settings of the controller can be adjusted by
simply using the three buttons on the front panel of the controller. Be sure to press the OFF button when you
have selected the parameter value wanted. By not pressing the off button to set the value, the value of that
parameter will not be stored into memory and remain at it’s previous setting.