23
Problem
Possible Cause
Solution
Off-road electric
runs sluggishly
Riding conditions
are too severe
Use only on solid, flat, clean and dry surfaces
such as pavement or level ground.
Tires are not
properly inflated
Product is
overloaded
Brake is not
adjusted properly
The tires are inflated when shipped but they
invariably will lose some pressure between the
point of manufacturing and your purchase. Refer
to instructions on page 12
Make sure you do not overload the product
by allowing more than one rider at one time
exceeding the 220 lb. maimum weight limit, going
up a hill or towing objects behind the product.
Adjust the brake pursuant to the instructions on
page 16
Brake function
not good
Brake is not
adjusted properly
worn brake
accessories or
cables
Adjust the brakes pursuant to the instructions on
page 16
Contact Dynacraft for replacement.
Sometimes the
off-road electric
scooter doen’t
run, but other
times it does
Loose wires or
connectors
Check all wires around the motors and all
connector to make sure they are tight.
Motor or electrical
switch damaged
Replace with a new motor or electrical
switch. Visit the Dynacraft website:
www.
dynacrafwheels.com
Charger unable
to plug into the
off-road electric
scooter charging
port
Check to see if there is any dust or debris. If there
is, gently draw the debris out with small stick.
(Do not use needles or any other metal objects ot
remove the debris, as this could lead to a short
circuit.)
Nosiy sounds
when ridding
Moving parts need
lubricated
Lubricate according to owner’s manual.
Moving parts wear
or tear
Replace with new parts.
Front fork not
turning freely
Need lubricated
Lubricate according to owner’s manual.
