DYNACORD
8
2.3 Quick Start
CAUTION:
After installing the system, first switch on the mixing console and position the mixer’s master faders to
their minimum settings. That followed, switch on the D 11A and use the master faders to adjust the
desired volume setting. Otherwise, high sound levels caused by unintentional playback of a program
source could be the result, which might cause hearing damage.
This Quick Start Manual outlines setup and operation of
the D 11A connected to a DYNACORD CMS mixer.
1.
Place the D 11A, mounted on pole-mount stands to
the left and to the right. The lower edges of the
speaker systems should be approximately 1,8 meters
above the audience to provide sufficient coverage
and to prevent that listeners nearby are subject to
extreme sound levels.
2.
Using suitable XLR-type cables connect the Master
Outputs of your mixing console, e.g. DYNACORD
CMS 1000, to LINE IN of the D 11A. Position the mas-
ter faders on the mixer to their minimum setting.
Now, switch on the mixer.
3.
Connect the D 11A to the mains outlet using the sup-
plied mains cord. Plug the connector into the MAINS
IN socket. Use the Mains switch to power-up the
D 11A.
4.
Set the level controls VOLUME and LINE TRIM of the
D 11A to 0dB.
5.
Connect an audio source, e.g. CD player, to a line
level input of the mixer, e.g. CMS 1000. Set all rotary
controls of the mixing console input channel to their
center position. Adjust the input channel’s ‘Gain‘
control so that the Peak LED should not light at all or
blink only once in a while.
6.
Slowly raise channel fader and master faders on the
mixing console to the desired positions – i.e. volume
settings.
7.
Your system is now ready for operation. Individual
sound adjustments necessary can be made using the
controls of the mixer’s corresponding input chan-
nels.
8.
Now, have fun with your D 11A system!
9.
After use, first switch off the D 11A and then the mix-
ing console, so that distracting power-off noise will
not occur. When using a DYNACORD CMS mixer, no
power-off noise will be output from the ‘Master Out-
puts‘. This allows switching off the mixer first with-
out a problem.
Содержание D 11 A
