25
SC-14
24
SETTING UP YOUR FIREWOOD PROCESSOR
Read and understand this entire section for proper and safe
set up.
To set up the firewood processor conveyor, follow these steps:
!
1. Start by removing transport safety bars.
2. Turn the manual winch counter clockwise to lower the conveyor
to a convenient height for your processing needs.
NEVER stand underneath the conveyor.
ALWAYS USE SAFETY CHAIN ON CONVEYOR!
!
!
The DYNA firewood processor is a machine that can cause
great bodily injury or death to persons operating it incorrectly or
those within close vicinity.
It is the operator’s responsibility to keep him/herself safe and
those around him/her.
Never use the firewood processor for anything but wood
processing.
Be sure to always wear hard hat, safety goggles, and
safety clothing such as gloves, coats, chaps, boots and ear
protection.
Never reach into the saw area while the machine is running.
The chainsaw can cause serious injury.
Never reach into the splitting area with the machine running.
The log splitter ram and wedge can cause serious injury.
Never stand or walk underneath the conveyor. The conveyor
could collapse or falling blocks of wood may hit a person.
The conveyor can cause serious injury.
Never reach into any moving parts of the machine, such
as, chains, sprockets, saw bar, splitter ram, wedge, motors,
cables and even wood chunks.
ALWAYS use a safety chain to support the conveyor
securely, while conveyor is extended and while traveling in
the transport position.
ALWAYS, use safety chains on the hitch and use proper
lighting when traveling on a road.
ALWAYS keep out from under the logs on the deck. They
could drop and cause serious injury.
CAUTION! Maintain full attention on splitting wedge and
keep hand on splitter lever while splitting ram is in forward
motion.
Never operate the firewood processor while under the
influence of alcohol or drugs
!
!
!
!
!
!
!
!
!
!
!
SAFETY OVERVIEW
SC-12 / SC-12XP • SET UP
