13
UVCS LED Light-Curing Conveyor Systems User Guide
To Switch Between Manual and Timer Mode:
1.
From the main page, press the
button to open the Options Menu (Figure 11).
2.
Use the
and
buttons, so that
the “SELECT MODE” option
is flashing and press the
button to
open the Select Mode Menu (Figure 12).
3.
Using the
and
buttons, highlight the desired mode and press the
button.
4.
The mode has now been set and the screen should return to the main page.
Figure 11. Options Menu
Figure 12. Select Mode Menu
Adjusting Intensity
The output intensity can be adjusted from 10% (depending on the LED Flood configuration ordered) to 100%
in 1% increments. To adjust the intensity:
1.
From the main screen, press the button on the front control panel to enter the Options Menu
(Figure 13).
2.
Use the
and the
so that the “Adjust Intensity” option is flashing and press the button to enter
the Adjust Intensity Menu (Figure 14).
3.
Use the
,
, , or keys to adjust the intensity setting. Press the Set button to enter
the value and exit to the main page.
NOTE:
If you enter intensity that is too low for the LED Flood Array attached the unit, the unit will beep for
5 seconds, and the intensity will not change.
If you are operating in PLC mode, a PLC input signal allows intensity to be selected from this menu or
allows intensity to be controlled directly by the PLC.
Figure 13. Options Menu
Figure 14. Adjust Intensity Menu
