8
Tridak® Model 1001 Syringe Filling System User Guide
Assembly and Setup
Unpacking and Inspecting Your Shipment
When your system arrives, inspect the boxes for damage and notify the shipper of box damage immediately.
Open each box and check for equipment damage. If parts are damaged, notify the shipper and submit a claim
for the damaged parts. Contact Dymax so that new parts can be shipped to you immediately.
The parts listed below will be included in your shipment. If parts are missing, contact your local Dymax
representative or Dymax Customer Support to resolve the problem.
Parts Included in the Model 1001 Syringe Filling System
▪
Model 1001 with Foot Switch [1]
▪
Tube Assemblies
–
Luer Female [2]
▪
Reservoir [3]
▪
Rod Assembly [4]
▪
Airline Kit for Reservoir and Model 1001 [5 & 6]
▪
Allen Key Kit [7]
▪
0.32" Bleed Wire with Pull Ring [8]
▪
Model 1001 User Manual [9]
▪
Stopper Pin (for use with plunger-less syringes) [Not Shown]
Figure 2. Unpacking Diagram
Utilities Required
AIR: Clean, dry, non-lubricated air operating pressure of 60
–
90 psi
