9
Tridak® Model 1001 Syringe Filling System User Guide
Preparing the System for Use
Installing the Reservoir Support
1.
Place the Reservoir Support on top of the screw hole in the left side of the system base.
2.
Using the screw and washer provided, place screw with the washer through hole in base and attach
to Reservoir Support. Tighten the screw until the Reservoir Support is secure (Figure 3).
Figure 3. Reservoir Support Installation
Installing the Material Reservoir
1.
Slide the Material Reservoir Retainer (Figure 4, D) over the top of the Reservoir Support (Figure 4, B).
2.
Position the Material Reservoir Retainer on the Reservoir Support so that the bottom of the Retainer
is approximately 2 inches above the top of the Back Plate.
3.
Using the Height Adjustment Handle (Figure 4, C) tighten the Set Screw until the Material Reservoir
Retainer does not move.
