32
BlueWave® MX-Series Multichannel Controller User Guide
Alarms Screen
The Alarm Screen will display the current status of the controller and each emitter. The following is a list of
possible alarms.
Alarms
Emitter1-4
Interconnect Cable
Cable connection is compromised at startup
Emitter1-4 Lost
Communication
Cable connection compromised while running
or emitter communication failure.
Emitter1-4 Firmware
Error
Firmware has found a conflict in the
operation.
Emitter1-4 Light Guide
Not Installed
Emitter1-4 Light guide must be present, MX-
150 Only
Emitter1-4 LED Over-
Temperature
LED has reached its upper thermal limit.
Emitter1-4 Error
General Errors detected by system.
(Open LED, shorted LED, over-current)
Emitter1-4 LED Over-
Current
Current monitoring detected LED current
above limit.
Emitter1-4 Fan Speed
Low
Fan PWM/Tach signal is not detected.
Controller
Temperature Failure
Controller board temperature above limit.
Controller Voltage
Failure
Input Voltage below threshold value.
Controller FRAM
Failure
Problem detected with memory.
Figure 34. Alarms Screen
RESET ALARMS BUTTON - Pressing this button will reset all alarms, however if the error causing the alarm persists
the alarm will continue to be asserted.
