12
Dymax BlueWave® LED VisiCure® User Guide
Operation
The BlueWave LED VisiCure will arrive almost fully assembled. Please refer to the installation section of
this manual for installation of the lightguide, power cord, and footswitch. The system should be
positioned in a dry location that does not obstruct airflow around the unit.
IMPORTANT:
To ensure that exposure output of the system is obtained, be sure that the lightguide is
fully inserted and seated into the entrance fitting prior to tightening the set screw. Be sure to lightly
tighten the set screw to ensure the lightguide remains in place during use.
To energize the system, turn the main power switch from the “O” position to the “l” position; the power
supply and timer should begin to function.
Figure 7. Main Power Switch
Figure 8. Timer
CAUTION!
Always wear protective goggles or a face shield when working near UV or bright visible
light. Never look directly at the light-emitting end of a lightguide.
The timer located on the front panel of the BlueWave LED VisiCure is factory set to the most common
operating mode and recommended operation of the timer with the BlueWave LED VisiCure.
The front panel of the timer contains an LED display and keypad. The LED display has a reset indicator,
key-protect indicator, output indicator, preset value, set value, and timing operation indicator.
A brief description of each display and location:
Output Indicator
– Displays OUT in upper left corner of timer display. Displayed when relay is
switched on; is not displayed when relay is switched to off.
Present Value
– Four-digit segmented display in center of timer. Shows current status of time.
Set Value
– Four-digit segmented display in lower right corner of timer. Shows set length of time.
Reset Indicator
– Display on the left of meter face. Active when the timer is reset by pressing the
“RST” button on the lower left face of timer. Or when the rear panel PLC Safety Interlock is active.
“RST” can also be used to cancel a currently running exposure cycle
Key Protect
– Located on center left side of display. Will always be lit because the timer function
is programmed at the factory and locked before shipment.
