DM5 BOARD
- Settings and Functions (continued)
• The DM5 is not water resistant.
Excess moisture can cause damage
to electronic parts.
• Keep the board and all electrical
components clean of dirt, paint
and moisture.
• To clean the board, use canned air. If a
more aggressive cleaning method is needed,
lightly scrub the components with a soft,
dry brush. Heavy scrubbing will damage
the board.
W A R N I N G
BOARD SETTINGS AND CONFIGURATION MODE
There are five settings you can alter on the DM5 board with the DIP switches inside the grip frame
(see figure 2)
:
ABS
Anti Bolt Stick.
Eye Sensitivity
This setting changes how long the eye waits for the ball to set into the breech.
Trigger Sensitivity
This setting adjusts the delay between two trigger pulls.
Dwell
This is the time the solenoid is activated for.
ROF
Rate Of Fire when the eye is deactivated.
Anti Bolt Stick -
When ABS is activated, the dwell is increased after 15 seconds of non-use for the next shot fired.
This helps to prevent bolt-stick, but may result in higher velocity for the first shot.
ABS on
ABS off
(default)
Eye Sensitivity -
The eye sensitivity setting determines the time that is needed to allow the next ball to settle
into the breech. Too sensitive an eye setting may result in chopping and too high a setting limits
the maximum ROF that can be achieved. Optimal sensitivity setting varies between different
paintball brands and the loader used. There are 4 different settings available. These settings can
be achieved using DIP switches 2 and 3.
FASTEST
AVERAGE
SLOWEST
Setting 1
Setting 2 (default)
Setting 3
Setting 4
DIP 2 - off
DIP 2 - off
DIP 2 - on
DIP 2 - on
DIP 3 - off
DIP 3 - on
DIP 3 - off
DIP 3 - on
The most sensitive and fastest setting is 1; this should only be used with force feed loaders such as a HALO™.
The middle two settings are good for other agitated loaders. Setting 4 is for slower loaders.
Figure 2
5
W
W
W
.
D
Y
E
M
A
T
R
I
X
.
C
O
M
Содержание DM5
Страница 1: ... ...
