Dyconn Myth Series, Инструкция по эксплуатации

Страница: 12 / 22

Page 11
Figure 2-1
Step
【
2
】
Display Installation
Using improper screws or screw size may damage your monitor. If spacers are required,
be sure to use screws of the correct size. Proper screws will easily and completely thread
into the monitor mounting holes. Inadequate thread engagement in the monitor may
cause the monitor to fall.
It is the installer's responsibility to make sure the combined weight of all components does
not exceed the weight capacity of 17.6 lbs (8kg). Exceeding weight capacity can result in
severe personal injury or damage to equipment.
Gas Spring Arms will only work when monitors are properly installed.
Note
: All Spacers or Screws used should be the same length.
Attaching the Display
1. Ensure the VESA bracket (1) can swivel and tilt easily (See Figure 2-1) . If necessary,
adjust the tension before proceeding to the next step.
2. Carefully place the display face down on protective surface ( See Figure 2-2 ).
Figure 2-2