- 3 -
1
4
5
HOT
COLD
2
3
SUPPLY STOPS
6
7
M965536 Rev. 1.7 (4/17)
4
3
TEST INSTALLED FAUCET
MAKE WATER SUPPLY CONNECTIONS
• Move HANDLE
(1)
into “off” position.
• Turn on water supplies and check all connections for leaks.
• Pull HAND SPRAY
(2)
from HOLDER
(3)
and disconnect HAND SPRAY
(2)
.
Pull HOSE
(4)
(HOSE should pull approximately 2 feet)and direct open HOSE END
(4)
into sink.
• Operate handle, in COLD and HOT positions, to flush water lines thoroughly.
• Connect HAND SPRAY
(2)
to HOSE END
(4)
.
Place HAND SPRA
Y (2)
back into faucet, operate
HANDLE
(1)
and check all connections for leaks.
• Check HAND SPRAY
(2)
operation with
faucet on, push front of LEVER
(5)
for
a broad cleansing spray.
TROUBLE SHOOTING
Low water flow from faucet:
• Remove check valve assembly and check
fordebris. Clean if necessary.
• Remove back flow preventer from spray head
and clean if necessary.
• Remove AERATOR
(6)
and clean if necessary.
Pull-Out Spray will not remove from faucet freely:
• Check that pull-out spray hose is not obstructed with
plumbingconnections or fittings under faucet.
• Make sure hose is not twisted or bound in faucet body.
• Turn off hot and cold water supplies before beginning.
• Connect FLEXIBLE SUPPLIES
(6, 7)
directly to wall supplies.
Connection on fitting supplies are 3/8" compression. Connect
left supply (Marked Red) to Hot and right supply (Marked Blue)
to Cold wall supply. Use adjustable wrench to tighten connections.
Do not over tighten.
• Faucet supplies are 21" long from faucet base.
Note: If additional supply length is required, installer must
purchaseadditional parts separately.
Impor tant: If SUPPLY HOSES (6, 7) are too long,
loop asillustrated to avoid kinking.
2
CONNECT SPRAY HOSE
• Slide COUPLING NUT
(1)
of SPRAY HOSE
(2)
onto end of OUTLET
(3)
.
Tighten with wrenchesto make a water tight connection.
• With HAND SPRAY seated in faucet body,install WEIGHT
(4)
onto HOSE
(2)
using two SCREWS
(5)
. Locate the WEIGHT
(4)
two feet (2') from the underside
of the sink deck.Tighten SCREWS
(5)
firmly.
CHECK
CONNECTIONS
FOR LEAKS
2
1
3
4
6
5
