DX Engineering SkyHawk 3X10, Инструкция по эксплуатации, Страница: 9 / 20

9
Assembly - Driven Elements
10DR 15DR 20DR
□ □ □
1. Locate the bag for the element you wish to assemble.
□ □ □
2. Locate one of the B element sections and slide the side with one hole into one of the A
element sections so all holes line up.
NOTE: If the holes don’t line up exactly, rotate one or both of the elements 180°.
□ □ □
3. Insert one end of the element insulator into the above assembly. Line up the holes and
pass a # 8 x 1-1/2 in (38 mm) screw followed by a # 8 lock washer and hex nut. Hand
tighten
□ □ □
4. Slide the side with one hole of the other B element section into the remaining A
element section so all the holes line up.
□ □ □
5. Insert the other end of the element insulator into the above assembly. Line up the hole
sand pass a # 8 x 1-1/2 in (38 mm) screw followed by a # 8 lock washer and hex nut.
Hand tighten
□ □
6. Locate one of the C element sections and insert the side with the two holes furthermost
from the end into one of the B element sections. Line up all the holes and secure with
two rivets.
□
7. Place a large cap over each element tip
□
8. Identify the completed 10 meter element section with a felt tip marker.
□
9. Locate one of the C element sections and insert the side with the three holes
furthermost from the end into one of the B element sections. Line up all the holes and
secure with three rivets.
□
10. Insert the other C element section into the other B element section as above and secure
with three rivets.
□ □
11. Locate one of the D element sections and insert the side with the two holes furthermost
from the end into one of the C element sections. Line up all the holes and secure with
two rivets.
□ □
12. Insert the other D element section into the other C element section as above and secure
with two rivets.
□
13. Place a small cap over each element tip.
□
14. Identify the completed 15 meter element section with a felt tip marker.
□
15. Locate one of the E element sections and insert it into one of the D element sections.
Line up all the holes and secure with two rivets.
□
16. Insert the other E element section into the other D element section as above and secure
with two rivets.
□
17. Locate one of the F element sections and insert it into one of the E element sections.
Line up all the holes and secure with two rivets.
□
18. Insert the other F element section into the other E element section as above and secure
with two rivets.
□
19. Place a small cap over each element tip
□
20. Identify the completed 20 meter element section with a felt tip marker.