14
□
6.
Insert a 1/4 x 2(51) U-bolt into the left hand pair of holes on the second boom saddle. Secure it
with 1/4 lock washers and hex nuts
□
7.
Insert a second 1/4 x 2(51) U-bolt into the right hand pair of holes on the same boom saddle.
Secure it with 1/4 lock washers and hex nuts.
□
8.
Insert the element compensator through the two U-bolts and center it.
□
9.
Tighten the nuts on each U-bolt leg evenly.
NOTE:
Do not over tighten the U-bolts as this will
only deform the compensator and possibly break it.
□
10. Sight down the boom and make sure that the elements all line up.
□
11. Straighten any out of line elements and re-tighten boom saddle screws as necessary.
Assembly - Element Spacer
The element spacers are designed to maintain the relationship between the three driven elements
providing unchanging performance under a wide variety of operating conditions. They will be
placed on element sections 20C, 15C and 10DR.
□
1.
Slide the large hole of one of the element spacers over the 20 meter driven element. As you
approach the 15 meter driven element, slide it through the center hole followed by the 10 meter
element through the end hole.
NOTE: Position the notched side of the holes to slide over the rivets.
□
2.
Position the element spacer so it rests against the end of element 20C.
□
3.
Slide one of the hose clamps over the 20 meter driven element until you reach the element
spacer. Securely tighten the hose clamp leaving about a 1/16" of clearance between it and the
spacer.
Repeat steps 1 through 3 for the remaining element spacer.
Содержание SkyHawk 3X10
Страница 17: ...17 Element Position...
