DX Engineering DXE-OTMC-250P, Инструкция по эксплуатации

Страница: 9 / 20

- 8 -
the bottom of the plate and the ground level. This will allow easy access to install the radial wire
hardware. The
DXE-RADP-3 Radial Plate comes with 20 sets of stainless steel hardware for
mounting the radial wires. Additional hardware kits are available from DX Engineering: DXE-
RADP-1HWK contains 20 sets of Radial Plate Hardware.
NOTE: If a larger diameter mounting
pipe is used (up to 2.5” OD) the
Optional Radial Plate will need a
larger clamp (DXE-SSVC-3P).
Optional DXE-RADP-3 Radial Plate Installation on customer supplied ground mounting pipe
Attaching the optional Ground Radial Wires to the Radial Plate
Using the 20 sets of supplied 1/4" stainless steel hardware (Bolt, Star Washer, Flat Washer, Split
Washer, Nut) connect the optional ground radial wires to the
DXE-RADP-3 Radial Plate as shown
below. Additional hardware kits are available from DX Engineering: DXE-RADP-1HWK
contains 20 sets of Radial Plate Hardware.
There are optional DX Engineering Radial Wire Kits available.
DXE-RADW-500K/BD contains a
500 foot spool of 14 gauge copper stranded wire with relaxed black PVC insulation, 20 Terminal
Lugs and 100 Steel or Biodegradable Lawn Staples. The
DXE-RADW-1000K/BD Radial Wire Kit
contains a 1,000 foot spool of 14 gauge copper stranded wire with relaxed black PVC insulation, 40
Terminal Lugs and 200 Steel or Biodegradable Lawn Staples.
RADW-20RT, -32RT or - 65RT
contain 20 each radial wires with 1/4" terminal attached. These kits come in 20 Ft, 32 Ft, or 65 Ft
lengths. See these and other options available listed at the
end of this manual.
Depending on the number of radial wires used, space them
out evenly around the Radial Plate like the spokes on a
wheel. The Radial Plate will accommodate up to 60 radial
wires (60 laser drilled holes), or up to 120 radials if doubled
up.
Radial Wire Hardware Installation Radial Wire Pattern