- 5 -
9. Using the supplied Allen Wrench and a customer supplied 1/2” open end wrench, tighten the
Nyloc hex nuts.
Note that when tightening the Nyloc Nuts in place, you DO NOT want
them completely tightened.
The Allen wrench used in combination with the open end wrench
as shown will not loosen the previously installed hardware.
When installed, you want to be able to tilt the plate, thus you need a slight gap as shown
below.
Using the Allen wrench and 1/2” hex wrench
Parts in place
Reference Drawing
Содержание DXE-OTMC-250P
Страница 12: ... 11 ...
Страница 15: ... 14 ...