DX Engineering DXE-OTMC-250P, Инструкция по эксплуатации

Страница: 4 / 20

- 3 -
3. Position the rear plate and the front plate together as shown below.
Rear Plate Front Plate
(Has DX logo)
4. Install a flat washer and hex nut onto one of the set screws as show.
Note: position these parts on the opposite end of the set screw that
has the hex wrench opening. Do the same for the second set screw.
5. Position the front and rear plates together and insert the set screws as shown below.
6. Using one of the Nyloc hex nuts as a measuring tool, adjust both of the set screws inward so
when the Nyloc hex nut is installed and tightened during a later step, there will be
approximately three exposed threads sticking out. Using a 1/2” open end wrench helps to hold
the hex nut in place while you turn the set screw.