Durr EcoGun AS MAN 1AF, Руководство по эксплуатации, Страница: 22 / 36

5. Push trigger through.
ð The valve pin (1) is pushed a little
backwards and out from the housing.
6. Remove valve pin (1).
Fig. 15: Disassemble seal of the bushing.
7. Insert the assembly plug (6) in the
bushing (4).
8. Screw-in set screw (7) in the bushing (4)
using the assembly plug (6).
ð The seal (5) is pushed out from the
bushing (4).
Fig. 16: Disassemble seal
9. Push in assembly plug (6) carefully into
the gun housing behind the trigger lever.
The contact surface of the assembly plug
must point in the direction of the trigger
lever.
10. Push in installation wrench (8) carefully
into the gun housing from the back.
11. Push in dismantled needle (9) through
the installation wrench (8) into the gun
housing.
12. Push trigger through.
ð The seal on the inside is pushed on
installation wrench (8).
13. Pull out needle (9).
Fig. 17: Disassemble seal
SYNTHESO GLEP 1
14. Pull out installation wrench (8) with seal
(10).
15. Pull out assembly plug (6).
16. Replace worn out or defective compo-
nents.
Assembly
17. Slide seal (10) on the installation
wrench (8).
18. Lubricate seal (10).
19. Push in installation wrench (8) with seal
(10) from behind into the housing.
Press-in seal.
Faults
11/2017 EcoGun AS MAN 1AF - MSG00020EN 22/36