Duronic FN45, Руководство пользователя

Страница: 7 / 52

7
How to Set Up Your Fan
1. Set up the Pole
2. Set up the Base and Attach the Pole
4. Fixing the pole to the Fan Head
3. Setting up the Fan Head
Take the exterior tube (part 18), loosen the pole tightening cap (17) and pull
out the inner steel tube (16) adjusting to the required height. Re-tighten the
cap (17) to fix the poles to the correct height.
Unscrew the tightening screw (22) from the bottom of the fan base (20). Insert
the fixing plate (2
1
) to the underside of the base (20) and hold it in place,
while at the same time holding the assembled pole on the top side of the base.
Tighten it all together with the tightening screw (22).
The fan head should now all be assembled and attached to the control box.
Next, loosen the control box screw (13) and place the whole assembled fan
head with control box onto the inner tube (16) and fasten in place by tightening
the control box screw (13).
a) Loosen and remove the tightened fastening nut (6) from the fan head (9).
b) Place the back cover (7) over the shaft pin (8) on the fan head. Tighten it in
place using the fastening nut (6).
c) Place the fan blade (5) on top of the fastening nut (6).
d) Next, screw on the blade cap (4) to secure the fan blade.
e) Put the front cover (1) on top. Secure both covers together using the cover
ring (2) and the cover ring screw (3).