Dürkopp Adler 650-16, Руководство по эксплуатации

Страница: 50 / 150

Control with the OP3000 control panel
48 Operating Instructions 650-16 - 02.0 - 08/2016
The parameter values for the current step are shown in the display.
The program bar (1) shows the progress of the seam.
The number under the current step shows the outstanding length
of the step.
The program bar shows half the current step in bold.
Fig. 23: Sewing (2), Current step
Completed steps are shown fully in bold.
Fig. 24: Sewing (3), Completed step
The following table lists the functions that can be performed in the
course of the seam.
Key/Pedal Function
+/-
and
0 - 16
Temporary correction of the fullness value
(valid only for the current step)
2nd pedal
(optional)
Temporary correction of the fullness value or the
curve support
(depending on the setting in the techni-
cian level)
(valid only for the current step)
Knee switch Next program step

/

3
Stop forward/back or to the start of the step
Switch the sleeve side (if programmed) in the
1st step at the start of the step

/

Correction of the thread tension
The value is saved.
ESC, P, F, S,
OK No function assigned