Dürkopp Adler 650-16, Руководство по эксплуатации

Страница: 27 / 150

Operation
Operating Instructions 650-16 - 02.0 - 08/2016 25
4.5 Winding the hook thread
Fig. 6: Winding the hook thread
To wind the hook thread:
1. Fit the bobbin (2) on the bobbin shaft.
2. Thread the hook thread as shown in the following figure.
3. Wind the hook thread clockwise on to the bobbin core.
4. Swing the bobbin winder flap (1) against the bobbin.
5. Switch the main switch on.
6. Start sewing.
7. Once the bobbin is full, the winder switches off automatically
(

Service instructions ).
8. Pull off the bobbin, clamp the thread under the cutter (3) and
tear it off.
NOTICE
Property damage may occur!
Moving the bobbin without performing sewing can cause
damage to the presser foot and the bobbin case in the hook.
Activate bobbin mode if you wish to wind the hook thread
without performing sewing.
(1) - Winder flap
(2) - Bobbin (3) - Cutter
①
②
③