DURKOPP ADLER H868, Руководство по эксплуатации

Страница: 26 / 80

Operation
Operating manual H868 Version 00.0 - 07/2013 24
3. Guide the thread clockwise around the hook thread winding
tensioner (4).
4. Insert the thread in a wavelike manner through the 2 holes of
the hook thread guide (2): from bottom to top through the left
hole and from top to bottom through the right hole.
5. Guide the thread to the winding bobbin (3).
Figure 10: Winding on the hook thread - part 2
1. Clamp the thread behind the cutter (1) and tear off the loose
end behind it.
2. Fit the bobbin on the winder (2).
3. Turn the bobbin clockwise until it clicks.
4. Pull the bobbin lever (3) up.
The hook thread is normally wound on when sewing is in progress.
However, you can also wind on the hook thread without sewing
material, e.g. if you require a full bobbin in order to start sewing.
1. Switch on the sewing machine.
2. Press the foot pedal forwards.
The machine sews and winds the hook thread from the thread
(1) - Cutter
(2) - Winder
(3) - Winding lever
1
3
2
Damage to the sewing feet or needle plate
possible if the thread is wound on without
material.
Lock the sewing feet in place in the highest position
and adjust the sewing foot stroke to the smallest
value if you wind on hook thread without sewing
material.
ATTENTION