DURKOPP ADLER 4182i-1, Руководство пользователя

Страница: 10 / 11

8
5.2.5 Changes of setting parameters of the Mini-stop with regard to the original setting of the manufacturer
Parameter Parameter
number value
111 - maximum revolutions (according to the machine type)
116 180 revolutions of the trimmer
171-1E 25 First position of needle - start (only DA320G5350)
171-1A 85 First position of needle - end (only DA320G5350)
183 500 switching off delay of the trimming device after
having ended the sewing operation
192 237 angle of the delay of switching on the tensioners (only DA320G5350)
215 0 the last advancing section of the start bar counted
241 8 see 5.2.3 (DA320G5351)
282 1 see 5.2.3 (DA320G5350)
001 3 number of stitches of start bar - section 1
003 2 number of stitches of end bar - section 3
5.2.6 Indication of faults
Generation information
Display of the V810 V820 Meaning
electronics box
A1 InF A1 InF A1 When switching on the machine, the pedal is not in the zero position.
-StoP-
A2 -StoP- blinks symbol blinks Blocking of the motor running.
A3 InF A3 InF A3 The reference position is not set.
A5 InF A5 InF A5 Autoselect not set or erroneous.
Programming of functions and values
Display of the V810 V820 Meaning
electronics box
Jump back to 000 Jumb back to 000
or to the last or to the last InF F1 Erroneous code or parameter number inserted.
parameter number parameter number
Serious state
Display of the V810 V820 Meaning
electronics box
E2 InF E2 InFo E2 Low woltage in the network or short period of time between the network switching on and off.
E3 InF E3 InFo E3 Machine blocked or without attaining the required revolutions.
E4 InF E4 InFo E4 Interference due to insufficient earthing or defective contact.
Hardware failure
Display of the V810 V820 Meaning
electronics box
H1 InF H1 InFo H1 Commutation signal or invertor defective.
H2 InF H2 InFo H2 Processor defective.
6. Examination of sewing
Caution! Risk of injury!
Before threading a thread switch the main switch off and wait until the motor stops.
- Check the sense of turning the hand wheel – according to the arrow situated on it.
- Thread a thread.
- Choose sewing material.
- Switch the desirable function on the control panel of stopmotor. Examination should be carried out with selection of fancy bar.
- First sew slowly then speed up the sewing.
- If the stitch does not meet requirements, follow the first part of instructions manual or service book.