DURAVIT Pool, Руководство по эксплуатации

Страница: 26 / 52

26
again. As soon as the remote control is in radio range, the house symbol appears
on the operator's panel display.
What if the remote control still does not respond?
> For further causes, see chapter
“
Help in Case of Problems
”
.
7.8 Start integrated filling (optional)
> Press the
“
OK
”
button to access the menu.
> Select Settings > Water > Fill .
> Press the
“
OK
”
button.
The pool will start filling and a check mark appears next to Filling.
The filling will stop automatically as soon as the pool is filled.
7.9 Empty pool
> Press the
“
OK
”
button to access the menu.
> Select Settings > Water > Empty .
> Press the
“
OK
”
button.
The pool will start to empty and a check mark appears next to Emptying. When the
pool is completely empty, the blowing procedure begins after about five minutes.
> Wait until the blowing process is finished (about two minutes) and an additional five
minutes until the drain closes automatically.
“
Emptying in Process
”
message will go out on the operator's panel.
> Make sure the pool is switched off at the mains socket/switch.
8. Change Settings
8.1 Change / activate / deactivate PIN
The Settings menu and the ECO/Standby-mode can be protected by activating the PIN
function. If you do not want to do this, you can deactivate it by selecting
“
0000
”
as the
PIN.
> Press the
“
OK
”
button to access the menu.
> Select Settings > Change PIN .
“
PIN-request
”
is displayed on the operator's panel