TUF 500 ROOF
fig. 1
Step 2:
Position Roof so that the front overhang measures
140mm. Rivet roof to wall sheets using one rivet
every second Rib. Repeat at the other end ensuring
overhang measures 140mm.
Step 4:
Fit Roof Flashing as shown. When posi-
tioned correctly rivet through Roof Flashing
into Roof Sheet joins.
7
Step 1: Note:
Condensation can form on the under side of shed roof. If building paper is required, fit now.
Building paper will need to be supported by netting or roofing twine.
Standard Roof:
Position Roof Sheets as shown in
fig 1
. Make sure sheet joins at the back are flush. Riv-
et sheet joins, one rivet 200mm back from edge front and back. Fit two more rivets evenly spaced in centre of
each join.
Step 1a:
Roof with Clear Panel:
Refer Next Page
Step 3:
Line up ribs on the roof with ribs on the
walls. While someone holds the Front Plate
straight, nail the roof to Top Plate using
one 40mm Weatherseal nail beside each
rib. Repeat at the back.
Step 3a:
Roof with Clear Panel:
Refer next page
Sealed Rivet
Steel Washer
Clear Roof
Panel
Steel
fig. 2
