12
MK3A DOORS
Step 2:
Position right hand Door Track (B107) on
front wall up against underside of Roof, with
right hand end flush with the right hand cor-
ner. Pre
-
drill hole in centre and rivet in place.
Remove ALL drill filings
Step 3:
Hang right hand door in Door Track. At the
right hand end of Door Track, adjust up or
down so that the Door hangs parallel with
shed. Fit one rivet at right hand end to hold in
place.
Step 4:
Position left hand Door Track (A107). Follow Steps
2 and 3 to hang left hand Door. Where Door
Tracks meet in the centre, adjust up and down so
that the Doors fit snuggly together, then rivet in
place. Remove Doors. Pre
-
drill holes into each Rib
and at similar spacings into Overdoor Flashing. At
approximately 1/3 in from each end of Door Tracks
put a 50mm nail. Rivet rest of holes.
Step 1:
Top Door Tracks:
Mark the centre of the door-
way on the Overdoor Flashing. Position Centre
Door Stop on the front face of the Overdoor
Flashing and up against the underside of roof. Pre
-
drill holes and nail in place with 50mm nails.
Step 5:
Clean out ALL drill filings. Also make sure
the Wheels are cleaned of drill filings. Re
-
hang Doors, then insert door stops into the
pre drilled holes at end of tracks as shown in
diagram. Tighten with two spanners
Door Track
Bolt
Washer
Washer
Nut
Aluminium
Door Stop
DOOR
GUID
DOOR
CLADDING
BOT-
PLATE
Step 6:
Bottom Door Guides:
Slide Door to corner. Hang Door Guide (A108) on bottom of the Door. Make it flush with
Corner Flashing. Lift up approximately 3mm so that the Door will Slide freely. Pre
-
drill hole and nail in place us-
ing a 50mm nail. Slide to centre. Ensuring Door slides freely, pre
-
drill hole and nail Door Guide in place. Check
Door is not binding in the middle then pre
-
drill holes into each Rib at similar spacing into Door Step Flashing.
Nail off using 50mm nails. Repeat with other Door.
Note:
For sheds with Raised Base Plate option the Door Step Flashing will protrude down past the Bottom Plate. Attach
Door Guide with rivets.
