6
SPEED CONTROL SET UP
1. Center the throttle trim adjustment and turn on the transmitter.
2. Move the switch on the ESC to the “OFF” position and connect the battery.
3. Lift the chassis so its wheels are off the ground.
4. Turn on the ESC. It will “beep” once and the red light will begin to flash indicating
the ESC is in set-up mode.
5. Program the ESC by moving the trigger to
the full speed position, then to the full brake
position. Return the trigger to the neutral position.
The ESC will beep four times and the green light will come on,
indicating the ESC has been set up.
• Raise the antenna.
• Turn on the transmitter before turning on the ESC.
• Turn the transmitter wheel to the right—the front
wheels should turn to the right. If not, move the
steering servo reverse switch.
• When running, adjust the steering trim so the truck
tracks straight.
• Slowly pull on the throttle trigger. The Vendetta SC should
slowly move forward. If the truck goes in reverse, move the
throttle reversing switch on the transmitter. The throttle trim
knob may also need to be adjusted to find neutral.
• The receiver should be factory bound to the transmitter.
However, if you ever need to bind, follow these steps:
1.
Turn on the transmitter.
2.
Turn on the receiver via the switch on the ESC. If the
receiver is not bound, the LED light will not be on.
3.
Push and hold the bind button on the receiver until the
light glows red.
4.
Release the bind button.
5.
If the binding is successful, the LED will flash once and
then remain ON.
ALWAYS CHECK THE RADIO
OPERATION
BEFORE
EACH RUN
!
RADIO SYSTEM CHECK
Forward
Steering
Reversing
Switch
Throttle
Reversing
Switch
Steering
Rate
Steering
Trim
Throttle
Trim
On/Off
Reverse
NOTE:
If you do not wish to change the ESC settings, simply wait for the red light
to stop flashing (about two seconds) before moving the throttle trigger.
