❏
4. Install the throttle/brake servo into the slot next to
the fuel tank. Place the two servo mount blocks onto
the bottom of the radio plate. Then install the four
3x10mm self-tapping screws through the servo into the
servo mounts. Route the servo wire through the slotted
hole between the servo and the receiver battery holder.
❏
5. Reinstall the radio plate onto the chassis. Make
sure to reinstall the washer between the steering
bellcrank and the radio plate.
❏
6. Install the two servo mounting posts onto the
steering servo as shown (note location of servo spline).
Note that the hole in the bottom of the servo mounting
posts are off-center. Install the posts with the hole in
the bottom of the post as shown in the photo. This is to
help prevent the servo from hitting the center belt.
❏
7. Install the steering servo onto the chassis from
underneath using a 3x10mm flat head self-tapping
screw in the front hole which is countersunk and a
3x10mm round head self-tapping screw in the slotted
rear mounting hole. Route the steering servo wire
through the slotted hole between the steering servo
and the receiver battery holder.
❏
8. Install the receiver using the included double-
sided tape onto the top of the radio plate as shown.
Run the length of the antenna wire through your fingers
7
