❏
1. Install the “AA” batteries in the transmitter and the
receiver holders.
❏
2. Extend the transmitter antenna.
❏
3. Connect the steering servo, throttle servo and
receiver battery to the receiver.
❏
4. Extend the receiver antenna.
❏
5. Adjust the servo trims of the transmitter to the
neutral position.
❏
6. Switch on the transmitter.
❏
7. Switch on the receiver.
❏
8. Operate the steering and throttle control. Make
sure the servo arms move in proportion to the
movement of the steering wheel and throttle trigger.
❏
9. Switch off the receiver, then the transmitter.
❏
1. Remove the Street Force GP Touring Car from
the box.
❏
2. Remove the radio plate from the chassis by
removing the 7 screws as indicated in the above photos.
❏
3. Install the on/off switch into the slot in front of the
fuel tank. Install the switch up through the bottom of
the radio plate, then install the face plate onto the top
of the radio plate. Re-install the two screws through
the face plate and into the switch to secure it to the
radio plate. Be careful to put the switch plate on
correctly with respect to on and off switch positions.
RADIO SET-UP
PREPARING THE RADIO SYSTEM
6
ASSEMBLY OF THE STREET FORCE GP TOURING CAR PRE-BUILT VERSION (DTXC0050)
Servo Arm
Steering
Servo
Throttle
Servo
Receiver
Battery
Holder
4-AA Batteries
1
Antenna
4
Receiver
3
Receiver
Switch
7
Transmitter
5
6
8-AA Batteries
1
Antenna
2
8
Before installing the radio
system in the pre-built
DuraTrax Street Force GP
read the manufacturer’s
instruction manual and
follow the instructions
shown below.
