Duratrax DXR8-E, Инструкция по эксплуатации

Страница: 6 / 36

6
1 1 1 1 1 1 1 1
1
2
3
4
8x16mm Ball Bearing
Apply a small amount
of grease onto the O-ring
and output joint before
assembling.
Apply a small amount
of grease onto the O-ring
and output joint before
assembling.
Apply a small amount
of grease onto the O-ring
and output joint before
assembling.
Refer to the tuning guide at
duratrax.com for differential
oil setup tips.
Fill the differential with
differential oil until it reaches
the top of the cross pins.
Allow the oil to settle for a
few minutes and re-check.
Install the differential screws and finish
tightening them in order 1-4. This will
help ensure that the differential gear is
mounted flat against the differential
housing and properly sealed. Be careful
not to overtighten the screws.
Align the flat spots on
the gear shafts so they
key together.
2.5x10.8mm Pin
6x18mm Washer
6x18mm Washer
6x18mm Washer
8x16mm Ball Bearing
8x16mm Ball Bearing
2.5x10.8mm Pin
2.5x10.8mm Pin
3x8mm F/H Screws
3x10mm F/H Screws
3x10mm F/H Screws
x3
x2
MAINTENANCE GUIDE:
The following section is provided to help you with maintenance and repairs to your DXR8-E.
Pay extra attention to the notes and tips for proper assembly.
MAINTENANCE