Duratrax DXR8-E, Инструкция по эксплуатации

Страница: 4 / 36

4 4
FINISHING
Remove the receiver box lid from the buggy.
Install your receiver into the receiver box.
Tip:
Secure the receiver to the receiver box
using adhesive backed Velcro.
Install the ESC onto the chassis as shown.
Tip: Before permanently installing the ESC onto the chassis
put the ESC in place and check that the wires route properly.
Permanently install the ESC in place using a quality double-
sided tape (DTXR1215).
Remove the rear upper brace assembly and center diff/motor
mount from the chassis. Route the ESC/receiver wire using the
tabs located on the bottom of the diff/motor mount assembly
and re-install back into the chassis.
Tip: Make sure the ESC wires going to the receiver lay fl at
and are not pinched.
Locate the correct steering servo horn adapter (included
with the DXR8-E) and install it into the steering servo
horn. Do not install the servo horn yet.
25T
23T
24T
23T
23T
2mm*
2mm*
0*
1mm*
0*
Airtronics ® /Sanwa
Futaba
®
/Duratrax
Hitec ® /Hobbico ®
KO Propo
JR ® Propo
SERVO TYPE ADAPTER SPACER
Remove the front upper brace assembly and
install the steering servo. Note the direction
of the servo. Depending on the servo you are
using, you may need to use the included servo
spacers under the servo mount tabs to raise the
servo up so that it does NOT touch the chassis.
3x12mm screws
& 3mm washers
FINISHING GUIDE: