Duratrax DXR8-E, Инструкция по эксплуатации

Страница: 5 / 36

5 5
FINISHING
Re-install the front and rear upper brace assemblies onto the chassis.
Install your motor into the chassis then install your desired pinion.
Route your receiver antenna through the antenna mount on the receiver box lid
and re-install the receiver box lid onto the chassis. Make sure the servo leads
pass through the holes in the receiver box properly and are not pinched.
Route your receiver antenna wire through the antenna tube (not included) and
install the antenna tube into the receiver box lid.
Install your battery into the DXR8-E and center your steering trims on your
radio. Install the steering servo horn onto the steering servo and secure in
place.
If you are using a 4S battery, you will need to remove the battery spacer from
the chassis. If you are using (2) 2S batteries no change is required.
Paint and decal the body as desired.
3x12mm F/H Screws
Make sure the notch in the motor mount clamp
keys into the proper notch in the motor mount
cam before tightening the motor clamp screws.
Make sure the pinion
does not rub on the
motor mount cam.
1.5mm
4x12mm Screw
4x18mm Screw
Position
Position mark
3
4
5
6
7
8
9
2
1
18.4 2
18.0 2
N/A
16.8 3
16.5 2
16.1 1
15.5 4
15.2 3
14.9 2
14.4 5
14.1 4
13.8 3
13.5 6
13.2 5
12.9 4
12.6 7
12.4 6
12.1 5
11.9 8
11.6 7
11.4 6
11.2 9
11.0 8
10.8 7
N/A
10.4 9
10.2 8
N/A
N/A
9.7 9
47
11 12 13 14 15 16 17 18 19 20
46
45
SPUR
PINION
GEAR
RATIO
Final Gear Ratio
18.4 2
47
11
SPUR GEAR
PINION
GEAR
Position