10
measurement and the interval time between two measurements should be greater than
five minutes.
•
When current measurement has been completed, disconnect the connection
between the testing lead and the circuit under test.
TEMPERATURE MEASUREMENT
•
To measure temperature use the K-type probe.
•
Set the rotary switch to the “TEMP” range. If no probe is connected, the
environmental temperature value is displayed on the LCD.
•
Insert the K-type probe to the COM and TEMP terminals. The two “+” and “-” pins
of the temperature probe must be direct at the COM and °C terminals respectively.
•
The measured temperature value will be displayed on the LCD.
MAINTENANCE
Replacing the battery
•
When the meter displays the low battery symbol, replace the battery immediately
in order to maintain normal operation.
•
Disconnect and remove all test probes from any live source and the meter.
•
Open the battery cover on the bottom case with a screwdriver.
•
Remove the old battery and fit a new one into the battery holder.
•
Replace the battery cover.
Fuse replacement
Replacing the defective fuse should be done according to the following procedure:
•
To avoid electrical shock, remove the test lead and any input signal before opening
the bottom case.
•
Open the bottom case and then remove the blown fuse.
•
Replace it with a new fuse of the same size and rating.
•
Replace the bottom case and reinstall the screws.
Cleaning
•
Clean the meter with a clean, soft cloth.
•
Do not use any chemicals, abrasives or solvents that could damage the meter.
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF
ELECTRICAL & ELECTRONIC EQUIPMENT
These symbols indicate that separate collection of Waste Electrical and
Electronic Equipment (WEEE) or waste batteries is required. Do not dispose
of these items with general household waste. Separate for the treatment,
recovery and recycling of the materials used. Waste batteries can be
returned to any waste battery recycling point which are provided by most
battery retailers. Contact your local authority for details of the battery and
WEEE recycling schemes available in your area.
Made in China. PR2 9PP
V.1.0
