Duran Electronica STANDGAS HC, Инструкция по установке и эксплуатации

Страница: 7 / 12

7
I-manSTANDGASexp-v02
4. PROGRAMMING AND GAS GROUP SELECTION
STANDGAS HC & HC PRO detectors are provided with a microprocessor for functioning control. This is a great advantage
due that, through software and adequate algorithms, these detectors can be reprogrammed at installation for auto-
calibration and sensitivity auto-adjust without using gas. In addition, it allows selecting among an extensive list of gases
without ordering new detectors or storing detectors calibrated for different gases.
Remove JP3 located at the vertical module with the detector powered. Watch carefully the external LED blinking (see table
1 below).
When the number of LED blinking fits in with the gas group to be detected, place JP3 jumper again and watch that the
corresponding LED confirms its memorized group position by the number of blinkings.
Note: If JP3 is removed and after 90s no group has been chosen, the last memorized group will be automatically chosen.
Default programming is GR1.
Table 1
STANDGAS HC
GR1
R
1 Blink
GR2
RR
2 Blink
GR3
RRR
3 Blink
GR4
RRRR
4 Blink
GR5
RRRRR
5 Blink
Group Gas Relative response Installation height
1
Methane
100%
30 cm from ceiling
5
Hydrogen 30 cm from ceiling
5
Natural gas 30 cm from ceiling
5
2
Butane
55%
30 cm from floor

Propane 100 cm from floor
