Duran Electronica EUROSONDELCO, Руководство по установке

Страница: 14 / 96

38
© 2005 DURAN ELECTRONICA S.L.
All rights reserved · www.duranelectronica.com
38
CALIBRATION WITH GAS -2 modes-
MODE 1st Looking at the display of the module line and without a measuring instrument.
1. Press PROGRAMMING .
The module line will look for the number and type of detector that are connected, and “Detector Search” will
be displayed. Next “Calibration” and type of gas will be displayed on the top line; and in the bottom line will be
displayed the detector nº and its gas concentration.
Remove the detector cap and insert the adapter -optional-.
Apply gas at the indicated flow in the calibration tables on pag. 36 and wait to the reading to be stabilised.
Adjust the detector potenciometer called GAIN until obtaining a concentration equivalent to the target gas it has
been used (example: CO = 200 ppm).
2.
Press FORWARD to go to on to the next detector.
MODE 2nd Not looking at the display of the module line and with a measuring instrument.
Place the instrument in the 5V scale. Connect the negative to the GND point and the positive to the TP+ point.
Adjust the detector potenciometer called GAIN until obtaining a suitable reading in millivolts following the
calibration tables in page nº 36.
1. Press FORWARD to go on to the next detector.
PRINTING OUT PROGRAMMING
This menu allows you to print out the module line programming with all of its parameters. Make sure the printer is connected
to the equipment´s right side connector and switch it on.
1.
Press PROGRAMMING to print all parameters.
If the printer is not connected or switched on, “Fault Printer” will be displayed.
EXIT THE PROGRAMMING
1.
Press PROGRAMMING if you want to exit the Engineer Programming Menu.
2.
Press FORWARD to come back to the beginning of Engineer Programming Menu.